Removing The Optional Graphics Riser Card - Dell Precision Workstation 690 User Manual

1 card retention device
2 tab
NOTICE: An incorrectly attached graphics power cable may result in degraded graphics performance.
14. Connect the power cable to the power connector on the card.
For information about the card cable connections, see the documentation that came with the card.
15. Attach the graphics card bridge (if required for your dual-graphics configuration), pressing firmly so that it completely covers the connector tabs.
1 graphics card bridge (not present on some dual-graphics configurations)
2 power connectors (2)
3 dual-PCI Express graphics cards
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into the computer.
16. Replace the computer cover (see
Removing the Optional Graphics Riser Card
NOTE: To upgrade to or downgrade from a dual-graphics configuration (with the graphics riser card), you will need additional parts that can be ordered
from Dell. See Contacting Dell.
1. Follow the procedures in Before You
CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
Replacing the Computer Cover), reconnect the computer and devices to electrical outlets, and then turn them on.
Begin.