Master/Slave Fixture Linking; Mounting; Orientation; Rigging - Chauvet MiNSpot User Manual

Master/Slave Fixture Linking
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2. Connect the end of the cabl
connector to the input conne
proceed to connect from the output as stated above to the input of the following fixture and so on.
Often, th e setup for Master-Slave
and Standalone operation requires
tha t the first fixture in the chain be
initiali zed for this purpose via either
settings in the control panel or DIP-
switch es. Secondarily, the fixtures
tha ollow may also require a slave
t f
setting. Please consult the
"Operating Instructions" section in
this manual for complete instructions
for this type of setup and
configuration.
M ounting
O RIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
R IG G IN G
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable "C" or "O" type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
•
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
•
Safety cables must always be used.
•
Never mount in places where the fixture
humidity, extreme temperature changes
MinSpot
e coming from the first fixture which will have a (female) 3 pin
ctor of the next fixture consisting of a (male) 3 pin connector. Then,
will be exposed to rain, high
or restricted ventilation.
9
Hanging Clamp
Note!
Clamp is sold separately.
2007-08-23/15:49