Installation Instructions - Stairmaster ClubTrack 510 User Manual

grounded receptacle.The treadmill is designed to operate in a typical exercise
environment with adequate heat dissipation (1850 Watts maximum). Place the
treadmill on a flat surface, free of moisture and debris. Maintain a minimum
clearance of 1.5 feet on each side and 6 feet at the rear.

Installation Instructions

If you choose to install your treadmill without the assistance of your StairMaster
representative, follow the procedure given below:
Tools:
• Flat blade screwdriver
• 4-mm Hex key (allen wrench, provided)
• 13-mm Hex socket wrench
• Torque wrench, if available
1. Grasp the controller uprights and pull the upright tube ends over the
brackets. Lift the controller, pivoting the uprights until the upright
tubes slide down the brackets. Note: Gently pull slack from the
controller cable down to the bottom of the upright to keep from
damaging any wires.
Controller Upright
Bracket
INSTALLATION INSTRUCTIONS
Page 5