Nfc Board - HP EliteBook Revolve 810 G1 Maintenance And Service Manual

NFC board

Description
NFC board (includes NFC board cable)
Before removing the NFC board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service cover (see
Remove the NFC board:
1. Disconnect the NFC antenna cable (1) from the NFC board.
The NFC antenna cable is included in the bottom cover spare part kit, spare part number .
2. Release the zero insertion force (ZIF) connector (2) to which the NFC board cable is attached,
and then disconnect the NFC board cable from the system board.
3. Detach the NFC board cable (3) from the bottom cover. (The NFC board cable is attached to the
bottom cover with double-sided tape.)
4. Remove the Phillips PM1.5×2.0 screw (4) that secures the NFC board to the bottom cover.
5. Remove the NFC board (5) and cable.
Battery on page 33).
Service cover on page 34).
Component replacement procedures
Spare part number
716738-001
43