Bottom Cover - HP EliteBook Revolve 810 G1 Maintenance And Service Manual

Bottom cover

Description
Bottom cover (includes battery release latch, NFC board antenna cable, power connector cover,
and RJ-45 jack cover)
Before removing the bottom cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the keyboard (see
Remove the bottom cover:
1. Remove the two Phillips PM2.0×4.3 screws that secure the bottom cover to the computer.
2. Close the computer.
3. Turn the computer upside down, with the rear toward you.
4. Disconnect the microphone cable (1) from the system board.
48 Chapter 4 Removal and replacement procedures
Battery on page 33).
Service cover on page
Keyboard on page 44).
Spare part number
716739-001
34).