Brother DCP-J125 User Manual page 46

Error Message
Cannot Detect
Cannot Print
Replace Ink
Cover is Open
Data Remaining
High Temperature
Ink Absorber Full
Ink Absorber NearFull The ink absorber box or flushing
Ink low
Low Temperature
Media Error
Media is Full.
38
Cause
You installed a new ink cartridge
too quickly and the machine did
not detect it.
If you are using non Brother
Original ink the machine may not
detect the ink cartridge.
An ink cartridge is not installed
correctly.
One or more of the ink cartridges
have reached the end of their life.
The machine will stop all print
operations.
The scanner cover is not
completely closed.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The print head is too warm.
Internal servicing required.
This problem may be caused by
the use of cartridges other than
genuine Brother Original
cartridges or the refilling of empty
cartridges with ink from other
sources. If damage is caused to
the print head or other parts of this
machine as a result of using other
brands of ink or ink cartridges, any
repairs required as a result may
not be covered by the warranty.
box is near full.
One or more of the ink cartridges
are near the end of their life.
The print head is too cold.
The memory card is either
corrupted, incorrectly formatted,
or there is a problem with the
memory card.
The memory card you are using
already contains 999 files.
Action
Take out the new ink cartridge and
re-install it slowly.
Replace the cartridge with a Brother
Original ink cartridge. If the error message
remains, contact your Brother dealer.
Take out the ink cartridge and re-install it
slowly until it clicks. (See Replacing the ink
cartridges on page 31.)
Replace the ink cartridges. (See Replacing
the ink cartridges on page 31.)
Lift the scanner cover and then close it
again.
Firmly close the ink cartridge cover until it
clicks.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
Allow the machine to cool down.
Call Brother Customer Service / your
Brother dealer.
Call Brother Customer Service / your
Brother dealer.
Order a new ink cartridge.
Allow the machine to warm up.
Put the card firmly into the slot again to
make sure it is in the correct position. If the
error remains, check the media drive (slot)
of the machine by putting in another
memory card that you know is working.
Your machine can only save to your
memory card if it contains less than 999
files. Try deleting unused files to free some
space and try again.