Table of Contents
Advertisement
OPERATION
System flush
After using detergents, flush the suction system by placing
the detergent suction tube into a bucket of clean water .
WARNING
NEVER turn the water supply off before turning the
engine/motor off .
Depressurize System
To depressurize, turn engine/motor off, turn water supply
off and squeeze gun trigger 2-3 times .
WARNING
NEVER disconnect the high pressure discharge hose from
the machine while the system is pressurized .
To reduce the risk of bodily injury or property damage,
always follow this procedure whenever spraying is
stopped, when work is completed, and before checking or
repairing any part of the system .
1 . Engage the trigger safety latch .
2 . Turn the unit off .
3 . Remove the ignition cable from the spark plug .
4 . Shut off the water supply .
5 . Disengage the trigger safety latch and trigger the gun
to relieve pressure .
6 . Re-engage the trigger safety latch .
7 . Before overnight storage, long term storage, or
transporting unit, disconnect the water supply and
turn off the fuel supply valve .
15
REV 76522-20130320
Operating Tips
CAUTION
Never operate your pressure washer without water .
CAUTION
Never connect your pressure washer to a hot water supply .
Connecting your pressure washer to a hot water
source will significantly reduce the life of the pump
and will void your warranty .
CAUTION
Running the unit for more than two minutes without
spraying water causes heat to build up in the pump .
In the event that the pump gets too hot, a thermal relief
valve will open to release the hot water .
Running the unit without spraying water can damage
pump components and will void your warranty .
76522
ENGLISH
Advertisement
Table of Contents
