Using The Ir Remote Control - HIKVISION DS-8100-S Series User Manual

HIKVISION DS-8100-S User‟s Manual
beep. The MENU/WIPER button will also bring up Sensitivity Interface settings. In PTZ Control
mode, the MENU/WIPER button will start wiper (if applicable).
•
F1/LIGHT Button: The F1/LIGHT button when used in a list field will select all items on the list.
In PTZ Control mode, it will turn on/off PTZ light.
•
F2/AUX Button: The F2/AUX button is used to cycle through tab pages. It will also bring up the
Channel & OSD Position settings.
•
MAIN/SPOT/ZOOM- Button: The MAIN/SPOT/ZOOM- button is used to switch to the control
of spot output. In PTZ Control mode, it can be used to zoom the camera out.
•
PREV/FOCUS- Button: The PREV/FOCUS- button is used to switch between single screen and
multi-screen mode. In PTZ Control mode, it is used to adjust the focus in conjunction with the
A/FOCUS+ button. It can also be used to select entire masked areas, such as in Motion Detection
and Privacy Mask menus.
•
PTZ/IRIS- Button: The PTZ/IRIS- button is used to enter the PTZ Control mode. When in the PTZ
Control mode, it is used to close the iris of the PTZ camera.
7. DIRECTION/ENTER Buttons:
•
DIRECTION Buttons: The DIRECTION buttons are used to navigate between different fields and
items in menus. In Playback mode, the Up and Down button is used to speed up and slow down
recorded video. The Left and Right button will select the next and previous day of recordings. In
Preview mode, these buttons can be used to cycle through channels.
•
ENTER Button: The ENTER button is used to confirm selection in any of the menu modes. It can
also be used to tick checkbox fields. In Playback mode, it can be used to play or pause the video. In
Single Play mode, pressing the ENTER button will advance the video by a single frame.
8. JOG SHUTTLE Control: The JOG SHUTTLE control can be used to move the active selection in a
menu. The inner ring will move the selection up and down; the inner ring will move it left and right.
In the Playback mode, the inner ring is used to jump 30 seconds forward/backward in a video. The
inner ring can be used to speed up/slow down the video. In Preview mode, it can be used to cycle
through different channels.
Note:
If GUARD indicator is blue (default), all alarm event and exception settings are valid. Otherwise, alarm event
and exception settings will be invalid, but normal recording will still be available.
Note:
It is important to note that you must click the EDIT button on either the remote or front panel on a text field
before you‟re able to edit its content. After you‟re done entering text, you must hit the ENTER button to be able to
move on to the next field.

Using the IR Remote Control

Your DVR may also be controlled with the included IR remote control, shown in Figure 4.
Batteries (2x AAA) must be installed before operating.
12