Troubleshooting - Teleco Flat Sat Elegance User Manual

Troubleshooting for Kit with Black Box and Sat Decoder (without Teleco TV)
If the Black Box does not turn on by pressing the button (1) or (6), check the following:
a) Are the RED and BLACK cables properly connected to the battery? The RED cable must
be on the + pole, the BLACK cable on the - pole. Should you have mixed up the cables, first
disconnect them, replace the safety fuse on the back of the Black Box using a similar one
(5 A), then re-connect the RED and BLACK cables properly to the battery.
b) Is the engine of your vehicle running? Turn it off, since this means the safety system which
keeps the antenna down is operating.
c) Have the connections been properly made? Check the connections in the installation
manual.
d) Are the remote control batteries properly charged?
e) Is the Black Box MIR visible and are you directing the remote control towards the MIR?
f) Are the Black Box and the Sat Decoder powered?
If the Black Box turns on by pressing the button (1) but the DECODER does not, check
the following:
a) Make sure that the DECODER is part of the Kit and that the connections described in the
installation manual have been made properly.
b) Is the Sat Decoder powered?
If the Black Box turns on by pressing the button (1) but the TV does not:
a) it is normal, as the TV is not part of the Kit and is therefore to be turned on via its remote
control.
If the Flat Sat Elegance has not found the satellite after a complete search, check the
following:
a) Is the view towards the South free from any obstacle?
b) Is the place you are at within the reception area (footprint) of the satellite you have chosen?
c) Is the cable connecting the LNB to the antenna firmly fastened? It could have been ripped
off or come loose because of contact with an unexpected obstacle.
d) Are all the connections on the Black Box properly set up? Make sure that the white coax
cable coming from the outside powered unit is connected to the LNB connector of the Black
Box.
If, when the satellite search is over, the screen is animated
as follows, check the following:
a) Is the scart jack of the DECODER connected to the scart jack
of the Black Box? Connect it as indicated in the Installation
manual.
b) Is the scart cable of the 21-pole type (are all connector poles
properly connected)? Use 21-pole scart cables only.
c) Is the DECODER off? Turn it on by pressing the button (3) on
the remote control.
22