Control Panel Operation; Starting Address - Chauvet Scan 300 RGB EU User Manual

4. O
PERATION



Control Panel
To access the control panel functions, use the four buttons located underneath the
display. When the product is on, the LCD monitor on the rear panel will show the current
Operation
operating mode (standalone or DMX). The product will retain the last saved settings when
powered off.
Menu Map
Configuration
(DMX)

Starting Address

Scorpion Scan 300 RGB EU User Manual (Rev. 1 ML)
This product is not designed for continual use. Make sure there are regular
breaks during operation to maximize the life of your laser.
Always disconnect the Scorpion™ Scan 300 RGB EU from power when not in use.
A Laser Safety Scanner Board is built-in. Laser light will automatically be turned
off when the scanned angle is less than 2°.
Button
<FUNC> Selects an operation mode or to backs out of the current menu option
<UP> Scrolls up the list of options or selects a higher value
<DOWN> Scrolls down the list of options or selects a lower value
<ENTER> Activates a menu option or a selected value
Mode Programming Steps
DMX
Slave
Sound-Active
AuF
Automatic
AuP
Remote rEn
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
Once the DMX cable is connected with the laser and the DMX controller, the DMX
indicator LED on the front panel will be On.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Scorpion™ Scan 300 RBG EU uses up to 17 DMX channels in its DMX mode, which
defines the highest configurable address to 496.
If you are unfamiliar with DMX, download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <FUNC> repeatedly until 001 shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.
Function
Description
001~512 Selects the DMX starting address
The slave product follows the actions of
SLA
the master product
SoF
The internal program runs to the beat of
the music (fast or slow)
SoS
AuS Automatic fast/slow; automatic sound-
sensitive mode fast/slow
SoF
Sos
Auto program; sound-sensitive auto
SoP
program
Sets the product to operate with the
optional remote controller
9