Safety Precautions - JVC VN-V686U Instructions Manual

● Before starting an important recording, be sure
to perform a test recording in order to confirm
that a normal recording is possible.
● We do not accept liability for the loss of a
recording in the case of it becoming impossible
to record due to a problem in the video camera,
VTR, hard disk recorder or video tape.
● The Automatic Tracking function, Intelligent
Tracking function and Motion Detection function
are simple functions and cannot be used as a
substitute for a security alarm. JVC shall not be
liable for any inconveniences or damages
caused in the event of error detection or when
these functions cannot be detected. We shall
not be liable for any inconveniences or damages
caused as a result of operational failure for alarm
input/output.
How to Read this Manual
Symbols used in this manual
Note : States precautions to be taken during
operation.
Memo : States restrictions on the functions or
use of this equipment. For reference
purposes.
A
: Indicates the page numbers or items to
refer to.
Contents of this manual
● JVC holds the copyright to this manual. Any part
or all of this manual may not be reproduced
without prior consent from the company.
● Windows is a registered trademark of Microsoft
Corporation in the U.S.
● Product names of other companies described in
this manual are trademarks or registered
trademarks of the respective companies.
Symbols such as
manual.
● Design, specifications and other contents
described in this manual are subject to change
for improvements without prior notice.
, and are omitted in this

Safety precautions

Mounting to a firm place
As the unit rotates at high speed, mount it on a
firm place with sufficient strength to support the
vibration and weight of the unit (approx. 5.5 kg).
If the strength is weak, the vibration will cause
fuzzy images on the monitor screen. In the worst
scenario, the camera may even fall off and hit
somebody, resulting in serious accidents.
Mounting the camera correctly with
the designated clamping brackets
Always use the designated clamping brackets.
Be sure to connect the fall prevention wire and
tighten the fixing screws or nuts securely.
Using the correct power and voltage
The rated power of this product is AC 24 V, 50
Hz/60 Hz. Supplying a power beyond the rated
value may result in failures and in the worst
scenario, smoking and fire.
This unit is able to divert lightening conduction to
itself and the connecting cables to a certain
extent but this is not 100 % guaranteed. For
installation locations that are likely to suffer
lightening strikes, be sure to take appropriate
measures such as adding arrestor to the
connecting cables.
Consult your dealer as special technique is
required when installing this product. Ensure
that the fixing screws or nuts are tightened
securely, otherwise, the unit may fall off.
Inspect the unit regularly.
Screws may be loosened due to vibration or
deterioration of the mounting section. Perform
regular inspections for loosened screws and
check whether there is any danger of the unit
falling off.
Do not hang on this product, shake it, or hand
objects over it. Applying an excessive load may
cause the product to fall off and result in
accidents.
Do not modify this product. It may result in
accidents.