JVC VN-V686U Instructions Manual page 107

B
Auto Function
Function
Patrol Mode
Target
C
Preset Position
For selecting the operation.
Click [Start] to start the selected Auto function. Click [Stop] to stop the running
Auto function.
A list of patrol modes appears when Auto Patrol is selected.
A list of targets appears when Intelligent Tracking is selected.
Auto Pan : The configured Auto Pan operation is performed.
(A Page 113)
Auto Patrol : The configured Auto Patrol operation is executed. Select
[Patrol Mode]. (A Page 60)
Auto Trace : The configured Auto Trace operation is performed.
(A Page 115)
Auto Tracking : Auto Tracking is performed. (A Page 55)
During Auto Tracking, Motion Detection deos not work.
(A Page 64)
Intelligent Tracking
: Intelligent Tracking is performed. (A Page 111)
Note:
● When the [Mode] item of [Auto Return] is set to Auto Patrol and Auto Patrol
starts in this screen, the Auto Patrol mode of [Auto Return] will be changed
to the mode that was started at this screen. [Auto Return] (A Page 54)
● When Auto Pan starts, the camera will repeat the left rotate, right rotate or
return operations. When Auto Patrol starts, the camera will complete a series
of operations and return to the start position, and then repeat the entire
process. When Auto Trace starts, the camera will perform a series of
operations before returning to the start position. It will resume after 30
seconds. If Auto Return function is set, Auto function that was started
manually is stopped when Auto Return starts.
For selecting the mode of the [Auto Patrol] function.
This feature can only be configured when [Function] is set to Auto Patrol .
For setting the target of the Intelligent Tracking operation.
Indoor : This setting is suitable for indoor targets.
Outdoor1(cloudy) : This setting is suitable for outdoor targets when the
contrast is not too strong, such as on a cloudy day.
Outdoor2(sunny) : This setting is suitable for outdoor targets when the
contrast is strong, such as on a sunny day.
For selecting the preset position.
When the selected position has been registered, the camera will move to the
selected position. (A Page 112)
Use the upper button to set positions in the tens and use the lower button to set
positions in the ones.
E.g.) To select Position Number 35
Click upper [31-40] and click lower [5]
E.g.) To select Position Number 50
Click upper [41-50] and click lower [10]
:
Memo
● When the upper [91-99] is selected, the lower [10] cannot be selected.