JVC VN-V686U Instructions Manual page 10

Getting Started
Precautions (continued)
Transporting the unit
Remove the connecting cables when
transporting the unit.
When transporting the unit, turn off the power of
the system.
Pack the unit with cushioning material so as to
avoid shock when transporting.
Handle the unit with care and do not subject it to
vibration or shock.
Transportation
Do not throw away the original box of the unit.
Keep it and use it for transporting the unit in
future.
As the camera unit is of an easily rotatable
structure, secure the camera unit inside the
dome cover such that it does not rotate before
transporting. Otherwise, an error may occur
during camera operation.
A
Face the heat release vents upward and
secure the lens section with tape.
B
Insert cushioning material wrapped with air
caps (approx. 50 mm x 200 mm) at two
opposite sides of the camera.
When the camera is mounted on a ceiling
clamping bracket, extend the tip of the fall
prevention wire outward to avoid it from being
caught in between during transportation. If the
fall prevention wire is caught, the camera and
the ceiling clamping bracket may not be able to
come off.
Secure with tape
A
Cushioning material
B
Extend the tip of the fall
prevention wire outward
Copyright Protection
With the exception of the user being the
copyright holder or when permission such as for
duplication has been granted by the copyright
holder, permission is required in principle for the
duplication, modification, or transmission of
copyrighted video and audio data.
Unauthorized duplication, modification, or
transmission of copyrighted material may
constitute a copyright infringement, and the
user may be liable to compensate for any
damages. When using copyrighted video/
audio data, be sure to check the license
agreement of the copyrighted material
thoroughly.
When rights or rights holders are involved
with regard to the targeted duplicating
subject, permission may be required for
shooting or using (processing) it. Be sure to
check the licensing conditions thoroughly.
Maintenance
Turn off the power before performing
maintenance.
Wipe using a soft cloth.
Wiping with thinner or benzene may melt or
tarnish its surface. For tough stains, wipe
using a cloth that is dipped into a neutral
detergent diluted with water, followed by
wiping with a dry cloth.
When the same position is monitored for 24
hours continuously over a long period, the
increased contact resistance on the horizontal
rotation section may cause noise interferences
in the images and operation from the computer
may become unstable. As such, this product is
equipped with an auto cleaning function that
performs cleaning once a week.
Disclaimer
The Automatic Tracking, Intelligent Tracking and
Motion Detection features do not prevent theft
or fire. Our company shall not be liable for any
inconveniences or failures that occur.
We shall not be responsible for any
inconveniences or disturbances caused in the
event of privacy invasion as a result of camera
footages of this product.