JVC VN-V686U Instructions Manual page 20

Connection/Installation
Mounting the Camera
(continued)
5
Mount the fall prevention wire
Mount the fall prevention wire, which is attached to
the camera, to the fall prevention wire fixing bracket
of the ceiling clamping bracket.
Caution
● Be sure to connect the fall prevention wire.
Otherwise, the camera may fall.
● To prevent danger, do not leave the fall
prevention wire dangling by the camera.
6
Mount the camera
● Align the D mark (blue)/(red) inside the
camera with the D mark (blue)/(red) on the
ceiling clamping bracket.
● Insert the camera into the ceiling clamping
bracket until you hear a click sound and mount it
securely.
7
Check that the camera fixing lock
knobs (x2) are sticking out.
If the camera is mounted on securely, the camera
fixing lock knobs (x2) will stick out a little.
Fall prevention
wire fixing bracket
6
D mark
(blue)
5
D mark (red)
Fall Prevention Wire
7
During
mounting
After
mounting
Note:
● Before mounting the camera, check that the
camera fixing lock knobs are not locked (i.e.,
lock knobs are on top). The camera cannot be
mounted if the lock knobs are locked.
● When pulling out the cables from the side,
remove the cable cover of the camera.
(A Page 16)
8
Lock
When the camera is mounted on the ceiling
clamping bracket, lower the camera fixing lock
knobs (x2) in the direction of the arrow and secure
the camera such that it does not fall off.
Caution
● Be sure to check that the camera fixing lock
knobs (x2) are locked securely. Otherwise,
the camera may fall.
● After mounting, check that the camera is
mounted securely. Improper mounting may
cause the camera to fall off.
Removing the Camera
A Slide the camera fixing lock knobs toward the
ceiling to unlock.
B Push in the camera fixing lock knobs (x2) from
the left and right and remove the camera.
C If the fall prevention wire is attached, reverse
the procedures to remove it.
Camera fixing
lock knob (x2)