Scan Resume Time; Key Beep (On/Off) - Vertex Standard VM-3500E Owner's Manual

10.7 SCAN RESUME TIME (Depends on the transceiver version)
This selection is used to select the time the VM-3500E waits after a transmis-
sion ends before starting scanning.
1. Press and hold down the [ CALL ( MENU )] key until
" Radio Setup
2. Press the [ ENT ] key, then select "
the " Radio Setup
tor knob.
3. Press the [ ENT ] key.
4. Turn the CHANNEL selector knob to select the de-
sired resume time. The resume time can be set to
1sec 2sec
" ," "
tion, the scanner will resume after the other station
stops transmitting (carrier drops).
5. Press the [ ENT ] key to store the selected setting.
6. To exit this menu and return to radio operation mode press the [ 16/9 ] key.
10.8 KEY BEEP ( ON/OFF )
This selection allows the beep tone when a key is pressed to be turned off.
1. Press and hold down the [ CALL ( MENU )] key until
Radio Setup
"
2. Press the [ ENT ] key, then select "
Radio Setup
"
knob.
3. Press the [ ENT ] key.
4. Turn the CHANNEL selector knob to select "
Off
" ."
5. Press the [ ENT ] key to set the key beep condition.
6. To exit this menu and return to radio operation mode
press the [ 16/9 ] key.
Emergency alarm and beeps for DSC operation cannot be turned OFF.
Page 52
" menu appears.
" menu with the CHANNEL selec-
3sec Off
," " ," or "
" menu appears.
" menu with the CHANNEL selector
SCAN Resume
Off
." In the " " selec-
Key Beep " in the
On
NOTE
" in
" or
VM-3500E