Vertex Standard VM-3500E Owner's Manual page 27

8.11.3 Priority Scanning P-SCAN
In the default setting, Channel 16 is set as the priority channel. You may change
the priority channel to the desired channel from the Channel 16 by the Radio
Setup Mode, refer to section "10.5 PRIORITY CHANNEL SET."
1. Adjust the SQL knob until background noise disappears.
2. Select a desired channel to be scanned using the
CHANNEL selector knob. Press the [ F ] key followed
by the [ 2 ( MEM )] key, "MEM" will appear on the LCD
which indicates the channel has been programmed
into the transceivers memory.
3. Repeat step 2 for all the desired channels to be scanned.
4. To DELETE a channel from the transceiver's memory, select the channel
then press the [ F ] key followed by the [ 2 ( MEM )] key, "MEM" will disappear
in the LCD.
5. To start priority scanning, press the [ F ] key followed
by the [ 3 ( SCAN )] key. "
Scanning will proceed between the memorized chan-
nels and the priority channel. CH 16 the priority chan-
nel will be scanned after each programmed channel.
6. To stop scanning, press the [ 16/9 ] , [ WX ] , [ CALL ( MENU )] , or PTT key.
You may change the scan resume time by the Radio Setup Mode, refer to
section "10.7 SCAN RESUME TIME."
VM-3500E
P-SCAN
" appears on the LCD.
Page 27