Table of Contents
Advertisement
VX-530 S
Preliminaries
If the transceiver has not been used since leaving the factory, fully charge
the battery using VAC-520 Rapid Desktop Charger before using it.
Mount the battery on the transceiver as described and shown in the illustra-
tion below. Also, install the antenna on the jack on top of the transceiver by
screwing the connector into the jack until it is finger-tight.
Battery Removal & Replacement
Make sure that the VOL control is set into the "off" click-stop (fully
counter-clockwise, and remove the protective soft or hard case, if used.
Grasp the transceiver with your left hand, so your palm is over the
speaker and your thumb is on the Battery Release Button.
Move the Battery Release Button in the direction indicated by the ar-
rowhead, while using your right hand to slide the battery pack toward
the side with the button. The battery pack should slide smoothly out of
its track.
To replace the Ni-Cd pack, repeat the second and third steps above,
simply sliding the battery case in the other direction after aligning the
shorter side of the battery pack with the track below the Battery Re-
lease Button.
Danger of explosion if battery is replaced with an incorrect battery.
Replace only with the same or equivalent type.
Page 4
O
M
B
Y
Caution
B
Vertex Standard Co., Ltd.
Advertisement
Table of Contents
