Table of Contents
Advertisement
VX-530 S
O
M
A
O
Follow-Me Scan
"Follow-Me" Scan feature checks a User-assigned Priority Channel regu-
larly as you scan the other channels. Thus, if only Channels 1, 3, and 5 (of
the 8 available channels) are designated for "Scanning," the user may none-
theless assign Channel 2 as the "User-assigned" Priority Channel via the
"Follow-Me" feature.
To activate "Follow-Me" scanning, first select the channel you want to
designate as the "User-Assigned Priority Channel" and Switch the Toggle
switch to the assigned position. Then turn the CH selector knob to the
"Scanning Start" channel which has been programmed by your dealer to
activate the scanner. When the scanner stops on an "Active" channel, the
User-assigned Priority Channel will automatically be checked every few
seconds; if activity is found on the User-assigned Priority Channel, the
radio will switch between it and the Dealer-Assigned Priority Channel, if
any.
Follow-Me DW
To set up a "Dual Watch" frequency pair using the "Follow-Me" feature,
select a channel using the CH selector knob. Now press the assigned Soft
key; pressing the assigned Soft key locks the current channel as the User-
assigned Priority Channel. Now rotate the CH selector knob to another
channel (not the "Scanning Start" channel). Your radio will now switch
back-and-forth between the currently-selected channel (shown on the CH
selector knob) and the User-assigned Priority Channel.
During "Follow-Me" scanning (after you have pressed the key), you can
set up the "Dual Watch" feature by rotating the CH selector knob to an-
other channel. The radio will then scan back and forth between the original
User-assigned Priority Channel and the newly-selected channel.
The Priority Channel you have assigned (before pressing the key) will be
retained in memory until you change it.
Page 15
Vertex Standard Co., Ltd.
Advertisement
Table of Contents
