Table of Contents
Advertisement
ACENT – Revenda Autorizada VERTEX | Locação | Vendas | Assistência Técnica | VENDAS: 0800 77-55-200 ou acent@radio-vertex.com.br
VX-520U O
Preliminaries
If the transceiver has not been used since leaving the factory, fully charge
the battery using VAC-520 Rapid Desktop Charger before using it.
Mount the battery on the transceiver as described and shown in the illus-
tration below. Also, install the antenna on the jack on top of the trans-
ceiver by screwing the connector into the jack until it is finger-tight.
Battery Removal & Replacement
¦ Make sure that the VOL control is set into the off click-stop, and
remove the protective soft or hard case, if used.
¦ Grasp the transceiver with your left hand, so your palm is over the
speaker and your thumb is on the Battery Release Button.
¦ Move the button in the direction indicated by the arrowhead, while
using your right hand to slide the battery pack toward the side with
the button. The battery pack should slide smoothly out of its track.
¦ To replace the Ni-Cd pack, repeat the second and third steps above,
simply sliding the battery case in the other direction after aligning
the shorter side of the battery pack with the track below the Battery
Release Button.
6
M
PERATING
ANUAL
O
www.radio-vertex.com.br
PERATION
Advertisement
Table of Contents
