Speed Dial - Vertex Standard VX-530 Series Operating Manual

VX-530 S O M
A O
Call/Reset
This feature, if enabled, allows the user to change the 3-digit Page Call
code, used to call other similarly-equipped stations. Press the Dealer-as-
signed Soft key, followed by the three digits representing the Page Call
code of the station you wish to call. Three tones will be heard after the last
key is pressed (the new code will now be transmitted).
The receiver squelch of the other station will be opened, and you can begin
communication.

Speed Dial

Your Dealer may have pre-programmed Auto-Dial telephone number memo-
ries into your radio.
To dial a number, press the Dealer-assigned Soft key for Speed Dialing,
then press the numbered key corresponding to the Auto-Dial memory num-
ber list provided by your Dealer. The DTMF tones sent during the dialing
sequence will be heard in the speaker.
Emergency
The VX-530 includes an "Emergency" feature which may be useful if you
have someone monitoring on the same frequency as your transceiver's chan-
nel. For further details contact your Vertex Standard dealer.
Monitor
Press the assigned Soft key to override both Tone and DCS Squelch. Press
and hold in the assigned Soft key for more than 2 seconds to override both
Noise and Tone/DCS Squelch. Press and hold in the assigned Soft key for
more than 2 seconds to quiet the noise and resume normal (quiet) monitor-
ing.
Lamp
Press the assigned Soft key to illuminate the Keypad/LCD for five sec-
onds.
Page 17
Vertex Standard Co., Ltd.