Advertisement
VX-530 Series Operating Manual
FCC RF Exposure Compliance Requirements for Occupational Use Only:
This Radio has been tested and complies with the Federal Communications Commission
(FCC) RF exposure limits for Occupational Use/Controlled exposure environment. In
addition, it complies with the following Standards and Guidelines:
FCC 96-326, Guidelines for Evaluating the Environmental Effects of Radio-Frequency
Radiation.
FCC OET Bulletin 65 Edition 97-01 (1997) Supplement C, Evaluating Compliance with
FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields.
ANSI/IEEE C95.1-1992, IEEE Standard for Safety Levels with Respect to Human
Exposure to Radio Frequency Electromagnetic Fields, 3kHz to 300 GHz.
ANSI/IEEE C95.3-1992, IEEE Recommended Practice for the Measurement of Potentially
Hazardous Electromagnetic Fields-RF and Microwave.
This radio is NOT approved for use by the general population in an uncontrolled
environment. This radio is restricted to occupational use, work related operations
only where the radio operator must have the knowledge to control its RF exposure
conditions.
When transmitting, hold the radio in a vertical position with its microphone 1 to 2
inches (2.5 to 5 cm) away from your mouth and keep the antenna at least 1 inch
(2.5cm) away from your head and body.
The radio must be used with a maximum operating duty cycle not exceeding 50 %,
in typical Push-to-Talk (PTT) configurations.
DO NOT transmit for more than 50 % of total radio use time (50 % duty cycle).
Transmitting more than 50 % of the time can cause FCC RF exposure compliance
requirements to be exceeded.
The radio is transmitting when the red LED on the top of the radio is illuminated.
You can cause the radio to transmit by pressing the PTT button.
DO NOT transmit when the radio is used in Body Worn configuration.
It must be used ONLY for (1) there is a 4 cm distance from the body during
transmitting, (2) monitoring purposes, using the speaker only and (3) for carrying
purposes.
Always use Vertex Standard authorized accessories.
Important Notice!
1/6
VX530 Series
Operating Manual
Vertex Standard Co., Ltd.
Advertisement
Table of Contents
Related Manuals for Vertex Standard VX-530 Series
Summary of Contents for Vertex Standard VX-530 Series
- Page 1 It must be used ONLY for (1) there is a 4 cm distance from the body during transmitting, (2) monitoring purposes, using the speaker only and (3) for carrying purposes. Always use Vertex Standard authorized accessories. Vertex Standard Co., Ltd.
- Page 2 Operation Preliminary Steps Install a charged battery pack onto the transceiver, as described previously. Screw the supplied antenna onto the Antenna jack. Never attempt to operate this transceiver without an antenna connected. Vertex Standard Co., Ltd.
- Page 3 VX-530 have the [SEL1], [SEL2], [MON], [LAMP] Key, ([A], [B], [C], [D] Key: if option is installed) and Toggle SW. The Key and SW function can be customized, via programmed by Vertex Standard dealer, to meet your communications requirements. Some features may require the purchase and installation of optional internal accessories. The possible KEY and SW programming features are illustrated below.
- Page 4 Therefore, if a signal is weak and you walk a few feet in any direction, reception may suddenly become clear, because a particular reflection path may become dominant. Reflections are frequently useful, as they can allow for communications between two stations over a highly obstructed path. Vertex Standard Co., Ltd.
- Page 5 Clone Cable (Set-to-Set Cloning) ATU-5D Antenna ATU-5EF Antenna Availability of accessories may vary; some accessories are supplied standard per local requirements, others may be unavailable in some regions. Check with your VERTEX STANDARD Dealer for changes to this list. Vertex Standard Co., Ltd.
- Page 6 Operation is subject to the condition that this device does not cause harmful interference. Part 15.21: Changes or modifications to this device not expressly approved by Vertex Standard could void the user’s authorization to operate this device. Vertex Standard Co., Ltd.
Need help?
Do you have a question about the VX-530 Series and is the answer not in the manual?
Questions and answers