Auto Mode; Sleep Mode - Hotpoint MAC155 Owner's Manual

AUTO MODE

1. Properly install the exhaust hoses.
2. Plug the power cord into a grounded outlet.
3. Turn on the unit by pressing the On/Off button on the control panel.
4. Press the Mode button until the "
5. Press the Fan button to select the fan speed.
During the Auto mode, The unit operates in dehumidifying mode when the room temperature is
° °
between 68 F - 73 F.
You may use the timer with the Auto mode.
PURIFY
1、This bottopn in only available under the operation mode of air purify (hepa be faxed in to the filter)
2、This botton can be as on and off bottopn under the operation mode of air purify.
3、When " " keep light,means unit is under the operation mode of air purify.
4、This icon"

SLEEP MODE

(This mode can only be programmed from the remote control.)
1. The air conditioner will need to be in operation.
2. Press the Sleep button. The "
3. The fan motor runs at low speed.
4. When in cooling mode, the temperature will increase 1
the temperature will stay 2
the unit will shut down.
5. When in heating mode, the temperature will decrease 1
the temperature will stay 2
unit will shut down.
6. When in dehumidify mode, the temperature will not change.
NOTE: If the unit is turned off during cooling, dehumidifying, and then restarted, there will be a 3 minute
delay before the compressor will turn back on to prolong the life of the compressor. Once the power recovers
and the compressor restarts, the unit will return to the original working mode.
" icon appears on the multi-color display.
The unit operates in cooling mode when the room temperature is above 73
"keep flame,means the hepa need be changed to a new on.
" icon appears on the multi-color display.
°
F higher than the originally set temperature for 6 hours. 6 hours later,
°
F lower than the originally set temperature for 6 hours. 6 hours later, the
12
°
F per hour during the first two hours. Then
°
F per hour during the first two hours. Then
°
F.