NAPCO FREEDOM Manual page 18

TBL READY
Flashes /
Flashes
Touchpad beeps
6 NONE Lost Key Mode
7 NONE Fire Zone Trouble
1 1* Wireless Receiver or
F-TP Touchpad TBL
Wireless Receiver Jam
2 2*
Wireless
3 1-8*
Transmitter Low
Battery
Wireless
4 1-8*
Transmitter
Supervisory Failure
Wireless Smoke
5 1-4*
Detector Low
Battery
Wireless Smoke
6 1-4*
Supervisory Failure
*In systems using the wireless Touchpad, two doors can be monitored by the Touchpad. If the secondary door deadbolt (the door not used when exiting) is
not locked, the green Ready LED will be off, not allowing the system trouble codes to display. Be sure the secondary door deadbolt is locked.
18
SYSTEM TROUBLE ERROR CODES
Trouble Condition
This is a reminder that the system has been put into the lost key mode ([STAY] & [AWAY] pressed simultane-
ously). While in this mode, the system can only be disarmed with your F-IFOB. When you have replaced or re-
keyed your deadbolt, press [STAY] & [AWAY] simultaneously again to exit lost key mode.
A problem has been detected with the Fire zone. Call for service.
A problem has been detected with the wireless receiver or F-TP Touchpad. Call for service.
A jam has been detected with a wireless receiver. Call for service.
The battery in a wireless transmitter is low and must be replaced. The transmitter is on the zone corresponding
to the number of READY flashes. The replacement battery for the GEM-TRANS2 door/window transmitter, F-
LTRANS deadbolt wireless transmitter, GEM-PIR motion detector and GEM-GB glass break detector is the
Duracell DL123A 3 Volt Lithium (2 required for the GEM-PIR and GEM-GB). The GEM-DT Dual Technology
Sensor requires 4 C cell Alkaline batteries. Note: If zone 1 or 7 is indicated, it may be a Primary or Secondary
F-LTRANS trouble. Remove cover and observe the LED. If blinking once every two seconds, replace battery.
Warning: Replace batteries only with the same type as specified above. Use of another battery may present a
risk of fire or explosion. Do not recharge or disassemble battery, or dispose of in fire.
A problem has been detected with a wireless transmitter on the zone corresponding to the number of READY
flashes. Call for service.
The battery in a wireless smoke detector is low and should be replaced. The number of the smoke detector
corresponds to the number READY flashes. The replacement battery is the Duracell MN1604 9 Volt Alkaline
(2 required). Warning: Replace batteries only with the same type as specified above. Use of another battery
may present a risk of fire or explosion. Do not recharge, disassemble, or dispose of battery in a fire.
A problem has been detected with a wireless smoke detector. Call for service.
Action