Media; Registration Time Out; Proxy Server Address; Keep Alive Interval - Mitel UC360 User Manual

UC360 Administration and User Guide

Media

Under Media, set the following parameters:
- Audio CODEC List — specify the preferred order for audio CODEC usage. Refer to
the section on CODECs and bandwidth in the UC360 Engineering Guidelines for more
information.
- Video CODEC List — specify the preferred order for video CODEC usage.
- Packet Time — set the preferred packet time from 20 ms to 100 ms in 10 ms
increments. A packet time of 20 ms is recommended. Note: Certain CODECS may
only operate in 20 ms increments.
- DTMF Mode — the UC360 sends DTMF signaling both in-band and out of band.
- DTMF Payload — set the In-Band payload number to a value between 96 and 127.
101 is the default value. It is recommended to leave this at the default value. For third
party SIP severs, consult the vendor's documentation as to how to set the DTMF
Payload value.

Registration Time Out

This is the SIP registration time out value in seconds. It is recommended to leave this at the
factory default setting of 3600 seconds.

Proxy Server Address

This is the SIP Proxy server IP address (IPv4).

Keep Alive Interval

This is the SIP keep-alive interval in seconds. It is recommended to leave this at the factory
default setting.
58