Media "Trees," Wrinkles, Stacks Poorly, Or Curls; Usb Port Service Check - Lexmark X264dn Service Manual

Media "trees," wrinkles, stacks poorly, or curls

FRU
Fuser

USB port service check

1.
Perform a print test to make sure the printer prints correctly. Verify that the indicator light is on, then print
the menu settings by selecting Print Menu under Utilities.
2.
Be sure the printer USB cable is designed for bidirectional printing.
3.
Be sure the user's application is set up correctly.
4.
If the internal print test page prints correctly, the user's application/printer driver is set up correctly, and the
correct USB cable is installed, but the printer still fails to print on command from the host computer, then
replace the controller board.
5.
Check the USB cable for continuity.
Action
This problem is most likely due to a worn backup roll. It causes the printer to run hotter than
required for the media being printed. Excessive heat can cause media treeing problems,
poor stacking, or curl.
Print the menu sheet found under Utilities.
Look at the media settings. Some, such as card stock or rough texture, may require a
higher fuser temperature, which leads to more of these problems (except stacking) in plain
paper.
• Change settings using the printer driver.
• Use the local printer setup utility (included on the CD) to change the NVRAM
settings.
Try a different ream of paper. Moist media has a higher tendency to crease (treeing) and
curl.
7013-XXX
2-33
Diagnostics information