Asc Automatic Stability Control; Control - BMW R 1200GS Rider's Manual

OE
with riding modes
First the ASC symbol changes
its display behavior. Press
and hold button 1 until ABS
warning lamp reacts. In this
case, the ASC setting does not
change.
The ABS warning lamp
lights up.
Release button 1 within two
seconds.
The ABS warning lamp
continues to light up.
ABS function is deactivated,
integral function continues to
be active.
Behavior with ABS
deactivated
With the ABS function switched
off, first only the control on the
front wheel is deactivated. If the
motorcycle is then only braked
with the handbrake lever, ABS
control continues to be active for
the rear wheel also braked via
the integral function. The ABS
control for the rear wheel is not
switched off until the footbrake
lever is actuated.
Switch on ABS function
Press and hold button 1 until
ABS warning lamp's display
changes.
The ABS warning lamp
goes out; if self-diagnosis
has not been completed, it be-
gins to flash.
Release button 1 within two
seconds.
The ABS warning lamp re-
mains off or continues to
flash.
ABS function is switched on.
As an alternative, the ignition
can also be switched off and
then on again.
If the ABS warning lamp
lights up after switching
the ignition off and on and then
continued driving over 3 mph
(5 km/h), an ABS error has
occurred.
ASC Automatic
Stability Control
OE
with riding modes
Deactivate ASC function
Switch on ignition.
The ASC function can
also be deactivated while
driving.
4
55
z