Wall Mounting The Telephone - Regency 200 Series User Manual

User's Guide

Wall Mounting the Telephone

Wall Mounting the Telephone
1 First, remove the clip provided in the
set by sliding it straight up (Figure 1) ,
and replace with the Wall Mount Clip
found in the packaging, as shown
(Figures 2-3).
Figure 1
Regency™ Series 200 Single Line Telephone
7
Wall Mount Clip
Figure 2 Figure 3
User's Guide
Wall Mounting the Telephone
Wall Mounting the Telephone (Continued)
2 The bottom of the Regency 200 has a mounting wedge that
must be re-positioned for wall mount use. This wedge will allow
the telephone to be at the correct angle when wall mounted.
To install the wedge for wall mounting, press the two release
tabs as shown (Figure 4). The wedge will snap off (Figure 5).
Rotate the wedge 180 degrees and snap into place in the
wall mount position (lower end of base)( (Figure 6 & Figure 7).
Figure 4
Desk Top Position
Figure 6
3 Insert the short line cord into the jack at the rear of the
telephone. Plug the opposite end into the jack on wall.
Regency™ Series 200 Single Line Telephone
Figure 5
Wall Mount Position
Figure 7
8