Control Method Of Optional Accessory; New Mfc - Orion OLM-5510 User Manual

ORION

6. Control Method of optional accessory

6.1. New MFC

1) New MFC Connection
1. Connect power.
2. Connect female D-sub to the Com port in a computer.
3. Connect male D-sub to the RS-232C port in MLCD.
4. Install the MFC connected with RS-232C cable and a power adapter at the location of good
Remote controller reception.
5. Set the number of the connected MLCD units in advance. The number can be set only by the
Remote controller.
HOR
VER
MLCD"NxM"Configuration
ASConnect
AdaoterJack
USBConnect
(5V1A)
EthernetConnect
NewMFCFront
PCConnect
MLCDConnect
NewMFCRear
- 52 -
2) MLCD Set Configuration (e.g. X:5 sets x Y:6 sets)
Horizontal configuration
1. Press SET button .
ON OFF
BROADCAST
ON
1 2 3
SET
OFF
4 5 6
DVI 1
7 8 9
2. Press Left and Right buttons sequentially to enter the horizontal
DVI 2
0
configuration mode.
SET
A B
INFO
INFO
DVI CONVERTER INPUT
DVI PC DTV HDMI
VIDEO S-VIDEO HDSDI
3. When the 2 LEDs at lower right corner of each 7-segment
DVIC1 DVIC2 INFO AUTO
of lower line in the New MFC are turned on, the horizontal
OUTPUT FUNCTION
configuration mode is started.
HOR
REMOTE CONTROL
VER
4. Use the number buttons to set the numbers of MLCD sets in horizontal
line.
- e.g. If you want to set 5 for horizontal number, press "0" for ten's place
and "5" for one's place.
1 2 3
4 5 6
7 8 9
0
5. Pres SET button to finish the horizontal configuration mode.

SET
- 53 -
MLCD
Infinitely Expandable
HOR
VER
HOR
VER