Positioning The Speakers; Attaching And Removing The Headset From The Helmet Clamp - Cardo Systems SCALARIDER Q2 MULTISET PRO User Manual

not horizontally (Be sure to clean the selected area prior to the
gluing process).
4. Use the pre-moistened Towelette to clean the helmet area where
you want to install the Glue Plate. Allow to dry thoroughly.
5. Peel the foil cover from the Glue Plates' adhesive pad.
6. Place the Glue Plate into position according to #3. Press firmly 15
seconds on all 3 parts of the Glue Plate.
7. The adhesive pad bonds to full strength over the next 24 hours.
Therefore it is recommended to not use the headset during this 24
hour period.
8. Fasten the Clamp to the Glue Plate using the Allen screws that were
previously removed.
If you have purchased a helmet clamp version with the corded
microphone, please proceed as follows:
ATTACHING THE CORDED MICROPHONE CLAMP ON A
FULL-FACED HELMET
If you are using the corded microphone version, you must first make
sure your helmet clamp is attached to your
helmet as described in previous section
(ATTACHING THE CLAMP ON THE HELMET).
Clean the exact spot on the internal padding of
the helmet, opposite your mouth, where the
microphone will be placed and proceed as
follows.
a. Peel the foil cover from the adhesive Velcro pad and place the
Velcro pad on the chosen location opposite your
mouth.
b. Attach the microphone to the Velcro, as shown
in photo.
c. When done, tighten the screws of the clamp
8 scala rider Q2 MultiSet
® ™
pro

POSITIONING THE SPEAKERS

Attach the speakers to the Velcro inside
your helmet opposite your ears (short
speaker cord for the left ear [A] and the
long speaker cord [B] for the right ear).
You may want to use the supplied Velcro
pad.
Using two speakers inside the
helmet may be prohibited in
certain jurisdictions. If this is the
case, you should tuck away the
long corded speaker underneath
the helmet padding as follows:
Lead the speaker cord [B] along-
side the rim of the padding to
the right side and then back
to the left side, near speaker
[A]. Then place the speaker [B]
underneath the padding.
ATTACHING AND REMOVING THE
HEADSET FROM THE HELMET CLAMP
ATTACHING:
Slide the headset downwards along
the sliding panel until a clicking sound
indicates that the headset is locked in
place.
Speaker A
Speaker B
Cable
Speaker B
Speaker B
Speaker A