Attaching And Removing The Headset From The Helmet Clamp; Mounting The Headset On The Helmet - Cardo Systems Scala-rider Q2 User Manual

Cardo systems scala-rider q2: user guide
Table of Contents

Advertisement

| scala-rider Q2
3. Search for Bluetooth headsets on your GPS device by following
the device's instructions. Please consult your GPS device's User
Manual for more information.
4. If your GPS device prompts for a PIN or Passkey enter 0000
(four zeros).
5. Your GPS device will confirm that pairing has succeeded. The
headset will begin flashing slowly in Blue.
6. If you wish to use a Bluetooth mobile phone to make and
receive calls through the headset, you must now pair your
mobile phone to your GPS device by following your GPS
and/or mobile phone's instructions.
NOTE: If the Pairing process is not completed within two
minutes the headset will return to Standby mode.

MOUNTING THE HEADSET ON THE HELMET

The microphone/speaker clamp must be mounted onto the
helmet. Once mounted, the headset unit can be attached or
detached from the microphone/speaker clamp at any time.
Attaching the Clamp to the Helmet
1. Use the enclosed Allen Wrench to
loosen the two screws on the Back
Plate.
2. Slide the Back Plate between the internal
padding and the external shell of the
helmet. (If the external shell is too thick,
use the supplied plastic Extension Pad
by loosening the screws and fitting the
Extension Pad between the Back Plate
and the main body of the clamp.)
QGQ2_A5_021.indd 6
Allen
Wrench
Back
Plate
3. Adjust the clamp's location so
that the microphone is located
in front of the center of your
mouth, with the yellow sticker
pointing towards your mouth, and
then tighten the screws.
ATTACHING AND REMOVING THE
HEADSET FROM THE HELMET CLAMP
ATTACHING:
Slide the headset downwards along the
sliding panel until a clicking sound indicates
that the headset is locked in place.
REMOVING:
Your headset can be removed for
charging and storage by pressing
your finger gently against the tab
and sliding the headset up with
the other hand.
We recommend that you remove the
headset from the helmet when not in use.
SPEAKERS AND MICROPHONE POSITIONING
The microphone must be positioned vertically, not horizontally, in
front of the center of the mouth, with the yellow sticker pointing
towards the mouth.
Attach the speakers to the Velcro inside your helmet opposite your
ears (short speaker cord for left ear & long speaker cord for right ear),
or use the supplied Velcro pads.
6
| SETUP AND CONFIGURATION
CORRECT
INCORRECT
Press here to remove
2/19/08 1:52:02 PM

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scala rider q2

Table of Contents