Specifications - Bryston B100 Owner's Manual

B100 SPECIFICATIONS
POWER AMPLIFIER SECTION:
Power Output:
Input Impedance:
Sensitivity:
Distortion:
IMD:
Noise:
Slew Rate:
Power Bandwidth:
Damping Factor:
Power consumption:
Heat load:
PREAMPLIFIER SECTION:
Frequency response:
IMD or THD:
High Level Sensitivity:
Noise:
GENERAL:
Dimensions:
Weight:
100 watts per channel into 8Ω
180 watts per channel into 4Ω
50K ohms single ended
1v = 100 Watts into 8 ohms (gain = 28.28 or 29dB)
T HD+noise: < 0.005% 20Hz to 20kHz at 100 watts into 8 ohms,
< 0.010% 60Hz + 7KHz mixed 4:1
> 108dB below rated output (with 20Hz to 22KHz bandpass filter)
>60 volts per microsecond
<1 Hz to over 100 kHz
Over 500 at 20 Hz, ref. 8 ohms
idle 30va, maximum power 600va
idle 100 btu/hr., max power 288 btu/hr
20Hz to 20KHz, ±.05dB
<.007%
500mV
100dB @ 20Hz to 20KHz (ref: 1V input)
17" or 19" wide X 4.55" high X 14" deep
(433 or 483mm X 116mm X 353mm)
approx. 30 lbs (13.6kg.)
B100
INTEGRATED AMPLIFIER