Bryston B100 Owner's Manual
Bryston owner's manual integrated amplifier b100, b100-da & b100-p
Hide thumbs
Also See for B100:
- Owner's manual (12 pages) ,
- Diagram (1 page) ,
- Dimensional drawing (1 page)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Advertisement
Table of Contents
Related Manuals for Bryston B100
Summary of Contents for Bryston B100
- Page 1 B100 INTEGRATED AMPLIFIER OWNER’S MANUAL For models B100, B100-DA & B100-P...
- Page 2 The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
-
Page 3: Setup Recommendations
You may place your B100 integrated amplifier in any convenient location. Make sure you position the ampli- fier to maintain a direct line-of-sight between the hand-held remote and the remote sensor eye located on the front panel. If plugged in the B100 will remain in standby indicated by the RED power LED on the front panel. -
Page 4: Led Status Indicators
The B100 PREAMP OUT is also muted. You can adjust the volume setting of the headphones by using the volume control on the front of the B100 inte- grated amplifier. You may also utilize the remote control unit to adjust headphone volume. The headphones cannot be muted with the remote control unit or the front panel Mute. - Page 5 D4 LEDs, it indicates that the digital inputs D1 (SPDIF), D2 (SPDIF), D3 (TOSLINK) or D4 (TOSLINK) have been selected. In B100 & B100-P models: when illuminated green this LED indicates that the line level ana- log audio input AUX-2 has been selected.
-
Page 6: Programming The Handheld Remote Control
The power amplifier stage is not affected by PASS THROUGH mode. PASS THROUGH mode can only be set (or reset) by sending the 3 digit code “245” to the B100 either from the handheld IR remote control or via the RS232 serial data input. -
Page 7: Moving-Magnet Phono Stage Option
“245” code to the B100. To turn the deactivate PASS THORUGH mode, select the current Pass Through input and then send the “245” code to the B100. The “245” toggles PASS THROUGH mode on and off. - Page 8 B100 TWO CHANNEL POWER AMPLIFIER...
- Page 9 B100 TWO CHANNEL POWER AMPLIFIER...
- Page 10 There are no user serviceable parts inside the B100. Please refer any servicing to qualified personnel. BRYSTON LIMITED WARRANTY Bryston audio circuits are warranted to be free from manufacturing defects for twenty (20) years from the original date of manufacture. The warranty includes parts and labour.