Advertisement
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER &
BATTERY CARTRIDGE
I .
SAVE THESE INSTRUCTIONS
-
This manual
contains important safety and operating instructions for battery charger.
2 . Before using battery charger, read all instructions and cautionary markings
on (1) battery charger, (2) battery, and
(3)
product using battery.
3. CAUTION
-
To reduce risk of injury, charge only MAKITA Battery Cartridge
7000,7001,7002,9000,9001,9002,9100,9101,9101A. 9102,9102A.
9122,1200,1201,1201A, I 2 0 2 , 1 2 0 2 A , 1210,1211,1222 OR 1422. Other
types of batteries may burst causing personal injury and damage.
4. Do not expose charger to rain or snow.
5. Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury to persons.
6. To reduce risk of damage to electric plug and cord, pull by plug rather than
cord when disconnecting charger.
7 . Make sure cord
is
located
so
that it
will
not be stepped on, tripped over,
or
otherwise subjected to damage or stress.
8 . An extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a . That pins on plug of extension cord are the same number, size, and shape
b. That extension cord
is
properly wired and in good electrical condition; and
c. That wire size is at least a s large a s the one specified in the table below.
TABLE 1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
a s those of plug on charger;
I
Length of Cord (Feet)
I
25
I
50
I
100
I
150
I
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before
attempting to perform inspection or maintenance.
Recycling the Battery
The
only
way to dispose
of
a Makita battery is
to recycle it. The law prohibits any other
method
of
disposal.
Ni-Cd
i-
To recycle the battery:
1 .
Remove the battery from the tool.
2. a). Take the battery to your nearest Makita Factory Service Center
or
b). Take the battery to your nearest Makita Authorized Service Center or
Distributor that has been designated as a Makita battery recycling location.
Call your nearest Makita Service Center or Distributor to determine the location
that provides Makita battery recycling. See your local Yellow Pages under
"Tools-Electric'!
To maintain product SAFETY and RELIABILITY, repairs, maintenance or adjustment should
be performed by Makita Authorized or Factory Service Centers, always using Makita
replacement parts.
AWG Size
of
Cord
I
18
I
18
I
18
I
16
I
9 . Do not operate charger with damaged cord or plug
-
replace them im-
mediately.
IO. Do not operate charger if it has received a sharp blow, been dropped, or other-
wise damaged in any way; take it
to
a qualified serviceman.
1 1 . Do not disassemble charger or battery cartridge; take it to a qualified
serviceman when service or repair is required. Incorrect reassembly may
result in a risk
of electric
shock or fire.
12. To reduce risk of electric shock, unplug charger from outlet before attempt-
ing any maintenance or cleaning. Turning off controls will not reduce this risk.
6
Advertisement
