Safety Cover; Dust Bag - Makita LS1211 Instruction Manual

Install the outer flange and hex bolt, and
then use the socket wrench to tighten the
hex bolt securely by turning
it
counter-
clockwise while pressing the shaft lock.
Return the safety cover and the center
cover to the original position. Then tighten
the hex bolt to secure the center cover.
Lower the handle to make sure that the
safety cover moves properly.
I
/-Safety cover
I
-Socket
wrench
CAUTION:
Use only the Makita socket wrench provided to install or remove the blade. Failure to do
so
may result in overtightening or insufficient tightening of the hex bolt. This could cause
serious injury to operator or others in the general vicinity of the tool.
Safety cover
When lowering the handle, the safety cover
rises automatically. The cover returns to i t s
original position when the cut is complet d
and the handle is raised. NEVER DEFE&T
OR REMOVE THE SAFETY COVER. In
the interest of your personal safety, always
maintain the safety cover in good condition.
Any irregular operation of the safety cover
should be corrected immediately. NEVER
USE THE TOOL WITH A FAULTY
SAFETY COVER. If the see-through safety
cover becomes dirty, or sawdust adheres to
it
in sucha way that the blade and/or work-
- -
~~
piece is no longer easily visible, unplug the saw and clean the cover carefully with
a
damp
cloth. Do not use solvents or any petroleum-based cleaners on the plastic cover.
Dust
bag
To attach the dust bag,
fit
i t into the elbow.
When the dust bag is about half full, re-
move the dust bag from the tool and pull
the fastener out. Empty the dust bag by
tapping it lightly to remove as much dust
as possible.
NOTE :
If
you
connect a vacuum cleaner to your saw, more efficient and cleaner operations can be
performed.
8