Sea Eagle SailCat 14SC Owner's Manual page 5

Connect the power supply to a 12V battery
(car or marine battery) using the alligator clips
at the end of the extension cord. Connect the
red to the positive pole and the black to the
negative pole.
If you ordered the kit for the Turbo Electric
Pump you have the option of connecting the
pump to the portable battery. Connect the cord
at the end of the portable battery into the end
of the cord attached to the pump.
To charge the battery plug it into the battery
charger and then plug the charger into a
household electrical outlet. The light on the
battery charger will blink red until it is fully
charged. When it is fully charged the light will
be a solid green.
There is a small opening inside of the carry
bag so that you can carry the battery in one
compartment and the pump in another. This
makes the pump easy to transport and pro-
tects the pump from sand which could jam it.
Press the ON button to begin inflation.
The pump operates in two stages which can
be identified by the noise of the turbine at the
beginning followed by the piston. The pump
will automatically stop once the set pressure is
reached.
14 SailCat Parts
Cross Benches
The aluminum cross benches are approxi-
mately 79" long and 8" wide. They have four
plastic hooks bolted underneath.
Floorboards
The aluminum floorboards sit on top of the
cross benches once they are installed on your
SailCat. The floorboards can be identified by
the gray fabric which is inserted into grooves
in the aluminum bench. The floor is adjustable
so that it can be installed squarely on the pon-
toons.
4
Leeboards
The Sea Eagle SailCat is equipped with two
leeboards which are used to reduce sideways
drift or leeway. The attachment hardware for
the leeboards consists of bolts with large plas-
tic heads, rubber washer, steel washer and a
large plastic wingnut.
Leeboard Bracket
Leeboards are attached to the floorboards by
means of a bracket. One bracket is required
for each bench.
Underbars & Underbar Sleeves
Four aluminum underbars and two aluminum
underbar sleeves are used to add rigidity to
the pontoons.
Mast Step Base
The mast step reinforcement base bolts to the
front crossbench to stiffen the area where the
mast connects to the crossbench. The rein-
forcement base measures approximately 35" x
8".
Mast Step
The Mast Step is an aluminum tube that the
mast is inserted into. The mast step bolts to
the front crossbench.
Mast
The Sea Eagle SailCat utilizes a three piece
mast which is 18' tall. The sections sleeve to-
gether starting with the largest diameter sec-
tion at the bottom.
Rudder Oarlock (Rudlock)
The rudlock attaches to the rear crossbench
and is used with the oar/rudder. Comes com-
plete with rudlock, a white nylon ring, a 24"
line, two bolts, two knurled nuts and two
washers.