Keyboard Wedge - Honeywell MS4980 User Manual

I
NSTALLATION

Keyboard Wedge

1. Turn off the host device.
2. Plug the 15-pin socket end
of the cable into the 15-pin D-Type
connector on the MS4980 (see page 4).
3. Disconnect the keyboard from the host
device.
4. Connect the "Y" ends of the
communication cable to the keyboard
and keyboard port on the host device. If
necessary, use the male/female adapter
cable supplied with the scanner for
proper connections.
5. Plug the power supply into the power
jack on the PowerLink cable.
Check the AC input requirements
of the power supply to verify the
voltage matches the AC outlet.
The outlet must be located near
the equipment and be easily
accessible.
6. Connect AC power to the transformer.
7. The MS4980 will start to initialize. The white and blue LED will alternately
fade on and off for approximately three seconds. When the scanner has
finished initializing, the unit will flash the white LED three times while
simultaneously beeping three times. The low intensity blue LED will remain
turned on.
8. Turn on the host device. The scanner will automatically reboot after host
device is turned on.
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. Please refer to the MetroSelect Single-Line Configuration
Guide or MetroSet2's help files for instructions on changing the
scanner's factory default configuration. The scanner and host system
must use the same communication protocols.
See caution on page 5.
Figure 7.
7