Jet JWL-1642EVS Owner's Manual page 4

24. Check centers and center sockets in the headstock and tailstock to be sure they are free of dirt or rust
and oil lightly before inserting centers.
25. Test each set-up by revolving the work by hand to insure it clears the tool rest and bed. Check setup
at the lowest speed before increasing it to the operating speed.
26. Use the correct cutting tool for the operation to be performed and keep all tools in a sharpened
condition.
27. Use low speeds for roughing and for long or large diameter work. If vibration occurs, stop the
machine and correct the cause. See speed recommendations.
DIAMETER OF WORK
Under 2"
2 to 4"
4 to 6"
6 to 8"
8 to 10"
10 to 12"
12 to 14"
14 to 16"
28. When sanding, remove the tool rest from the machine, apply light pressure, and use a slow speed to
avoid heat build up.
29. When turning large diameter pieces, such as bowls, always operate the lathe at low speeds. See
speed recommendations.
30. Do not attempt to engage the spindle lock pin until the spindle has stopped. If leaving the machine
area, turn it off and wait until the spindle stops before departing.
31. Make no adjustments except speed change with the spindle rotating and always disconnect machine
from power source when performing maintenance to avoid accidental starting or electrical shock.
32. Provide for adequate surrounding work space and overhead non-glare lighting.
33. When stopping the lathe, never grab the part or face plate to slow it down. Let the work coast to a
stop.
34. Use only JET factory authorized replacement parts and accessories, otherwise the warranty and
guarantee are null and void.
35. Do not use this JET wood lathe for other than its intended use. If used for other purposes, JET
disclaims any real or implied warranty and holds itself harmless from any injury that may result from
that use.
ROUGHING RPM
1520
760
510
380
300
255
220
190
4
GENERAL CUTTING
RPM
3200
1600
1080
810
650
540
460
400
FINISHING RPM
3200
2480
1650
1240
1000
830
710
620