Floppy Disk Drive Connector - DFI G7S620-N User Manual

2
Hardware Installation

Floppy Disk Drive Connector

o
The 90 floppy disk drive connector supports two standard floppy
disk drives. To prevent improper floppy cable installation, the floppy
disk header has a keying mechanism. The 34-pin connector on the
floppy cable can be placed into the header only if pin 1 of the
connector is aligned with pin 1 of the header.
Connecting the Floppy Disk Drive Cable
Install one end of the floppy disk drive cable into the shrouded
floppy disk header (J21) on the system board and the other end-
most connector to the drive you want to designate as Drive A. If
you are connecting another drive (Drive B), install the middle connec-
tor of the cable to the drive. The colored edge of the daisy chained
ribbon cable should be aligned with pin 1 of J21.
BIOS Setting
Enable or disable this function in the Integrated Peripherals submenu
("Super IO Device" section) of the BIOS. Refer to chapter 3 for
more information.
45