CM1164 User Manual
Components
Front View
2
No.
Component
1
LED Status Panel This panel contains LED icons that light to indicate mode
2
Port Selection
Pushbuttons
3
Mode Selection
Pushbutton
4
OSD (Esc) button Press this to invoke the on-screen display (OSD) menu.
5
Select button
6
Direction /
Function buttons
7
Console Audio
Ports
8
USB 2.0
Peripheral Port
9
IR Receiver
6
1
3
2
and port status. The Mode and Port Selection Pushbuttons
each have three corresponding LED icons that represent
audio, KVM, and USB Link status. See LED Display,
page 16, for full details.
Press the Port Selection Pushbuttons to manually
switch ports. See LED Display, page 16, for full details.
Press and hold Port Selection Pushbuttons 1 and 2
simultaneously for 2 seconds to start Auto Scan Mode.
See Auto Scanning, page 30, for full details.
Press and hold Port Selection Pushbuttons 3 and 4
simultaneously for 2 seconds to execute a KVM reset.
See KVM Reset, page 26 for full details.
This pushbutton allows you to cycle through the three
modes of focus – KVM, audio, and USB Link.
When the OSD menu is enabled, press the OSD button to
go back to the previous menu/submenu.
Press this to select an option in the OSD menu.
Use these buttons to switch between Function modes (Fn1
to Fn4), and to cycle through the OSD menu/selection.
See IR Remote Control, page 8 for details.
Your speakers and microphone plug in here.
USB 2.0 peripherals (printers, scanners, etc.) plug into this
port.
This receives signals from the IR remote control.
4
7
6
5
Description
8
9