Table of Contents
Advertisement
14. Front Audio Connector
If the housing has been designed with an audio port on the front panel, you'll be able to
connect onboard audio to front panel through this connector. By the way, please remove
5-6 and 9-10 jumper caps from the Front Audio Connector before connecting the cable.
Please do not remove these 5-6 and 9-10 yellow jumper caps if there's no audio port on
the front panel.
Pin 1
1 2
AUD_GND
AUD_MIC
AUD_VCC
AUD_MIC_BIAS
AUD_RET_R
AUD_FPOUT_R
KEY
NC
AUD_RET_L
AUD_FROUT_L
9 10
15. Power-on and Load BIOS Setup
After you finish the setting of jumpers and connect correct cables. Power on
Del
and enter the BIOS Setup, press <Del> during POST (Power On Self Test).
Choose "Load Setup Defaults" for recommended optimal performance.
Warning: Please avoid of using "Load
Turbo Defaults", unless you are sure
your system components (CPU, DRAM,
HDD, etc.) are good enough for turbo
setting.
16. AOpen Bonus Pack CD
You can use the autorun menu of Bonus CD disc. Choose the utility and driver and select
model name.
17. BIOS Upgrade under Windows Environment
You may accomplish BIOS upgrade procedure with EzWinFlash by the following steps,
and it's STRONGLY RECOMMENDED to close all the applications before you start the
upgrading.
1.
Download the new version of BIOS package zip file from AOpen official web site.
(ex: http://english.aopen.com.tw)
2.
Unzip the download BIOS package (ex: WAX4CMAX102.ZIP) with WinZip
(http://www.winzip.com) in Windows environment.
3.
Save the unzipped files into a folder, for example, WAX4CMAX102.EXE &
WAX4CMAX102.BIN.
4.
Double click on the WAX4CMAX102.EXE, EzWinFlash will detect the model name
and BIOS version of your motherboard. If you had got the wrong BIOS, you will not
be allowed to proceed with the flash steps.
5.
You may select preferred language in the main menu, then click [Start Flash] to start
the BIOS upgrade procedure.
6.
EzWinFlash will complete all the process automatically, and a dialogue box will pop
up to ask you to restart Windows. You may click [YES] to reboot Windows.
7.
Press <Del> at POST to enter BIOS setup, choose "Load Setup Defaults", then
"Save & Exit Setup". Done!
Warning: The upgrade of new BIOS will permanently replace your original BIOS
content after flashing. The original BIOS setting and Wi2000/WinXP PnP
information will be refreshed and you probably need to re-configure your system.
Advertisement
Table of Contents
