Jp3 Tube Power Jumper; Connecting Ide And Floppy Cables; Front Audio Connector; Support Six Usb2.0 Connectors - AOpen AX4B-533 TUBE Easy Installation Manual

6. JP3 Tube Power Jumper

This JP3 jumper allows you to switch on/off power supply for Vacuum Tube. You may switch
the power off whenever you are not using Tube as your audio output in order to save the
power.
Note: For details of Vacuum Tube, please refer to our specially made Tube Manual.

7. Front Audio Connector

If the housing has been designed with an audio port on the front panel, you'll be able to
connect onboard audio to front panel through this connector. By the way, please remove
5-6 and 9-10 jumper caps from the Front Audio Connector before connecting the cable.
Please do not remove these 5-6 and 9-10 yellow jumper caps if there's no audio port on
the front panel.
Pin 1
1 2
AUD_GND
AUD_MIC
AUD_VCC
NC
AUD_RET_R
AUD_FPOUT_R
KEY
NC
AUD_FROUT_L NC
9 10
Pin 1
JP3 Tube Power
1
On
OFF
(Default)

8. Connecting IDE and Floppy Cables

Connect 34-pin floppy cable and 40-pin, 80-wire IDE cable to floppy connector FDC and
IDE connector. Be careful of the pin1 orientation. Wrong orientation may cause system
damage.
ATA 33/66/100
IDE Connector

9. Support Six USB2.0 Connectors

Compared to traditional USB 1.0/1.1 with the speed of 12Mbps, USB 2.0 has a fancy
speed up to 480Mbps, which is 40 times faster than the traditional one. Except for the
speed increase, USB 2.0 supports old USB 1.0/1.1 software and peripherals, offering
impressive and even better compatibility to customers. On this motherboard, all USB
connectors support USB 2.0 function. To connect those two headers, you have to use
proper USB cables and connect them to any USB models.
Pin 1
USB2 Connector
1 2
USBPWR0
USBPWR0
USB_FP_P1-
USB_FP_P0-
USB_FP_P1+
USB_FP_P0+
GND
GND
USB_FP_OC0
KEY
Secondary
Secondary
Master (3rd)
Slave (4th)
IDE 2 (Secondary)
IDE 1 (Primary)
Pin 1
Primary
Primary
Slave (2nd) Master (1st)
Pin 1
FDD Connector