Toyota Tacoma 2006 Operating Manual page 198

06 01.06
When initializing the system, the pres-
ent tire condition is stored as a stan-
dard.
To initialize the system, perform the fol-
lowing:
1. Park the vehicle at a safe place and
apply the parking brake. Stop the en-
gine.
2. Adjust the pressure of all the installed
tires (including the spare tire) to the
specified level. (See "Tires" on page
400 in Section 8.)
3. Turn the ignition key to "ON".
4. Push and hold the reset switch until
the low tire pressure warning light
blinks three times.
NOTICE
Initialization is completed within a few
minutes. When warning light blinks
after driving of about 20 minutes, try
to initialize again.
198
LS17025
When initializing the system, make sure
the low tire pressure warning light blinks
three times. If the warning light does not
blink three times, initialization failed and
the tire pressure warning system will not
function properly. In this case, initialize
the system again.
Do not push the reset switch without ad-
justing the tire inflation pressure to the
specified level. Otherwise, the low tire
pressure warning light may not come on
even if the tire pressure is low, or it may
come on when the tire inflation pressure
is actually normal.
2006 TACOMA from Jan.'06 Prod. (OM35865U)
If you push the reset switch while the
vehicle is moving, initialization is not per-
formed.
If the low tire pressure warning light does
not blink when you push and hold the
reset switch, have the low pressure warn-
ing system checked at your Toyota dealer.
CAUTION
Initializing the system must be per-
formed with all tires (including the
spare tire) adjusted to the specified
tire inflation pressure.