Toyota Tacoma 2006 Operating Manual page 197

06 01.06
—Replacing tires and wheels
When replacing the wheels, be sure to
install air pressure sensors
wheels.
There are 3 ways to set up the air pres-
sure sensors:
a. Remove the sensor from the old wheel
and install it to the new wheel.
b. Keep the same wheel with air pressure
sensor and replace only the tire.
c. Use a new wheel and sensor. In this
case, you have to register an ID code
for a new sensor.
CAUTION
Initialization should be performed
with the tires adjusted at the speci-
fied tire inflation pressure. If they are
not adjusted properly, tire inflation
pressure to be warned will not be
appropriate. Initialization is completed
within a few minutes.
NOTICE
on the
z Have the tires, wheels or sensors
replaced and ID codes registered by
a Toyota dealer. If you need sen-
sors, purchase from a Toyota deal-
er.
z The sensor nuts should always be
tightened to a torque of 4 N·m (0.4
kgf·m, 2.9 ft·lbf).
z The use of non- genuine wheels will
cause the air pressure sensors to
transmit the electronic code in dif-
ferent manner, resulting in the sys-
tem failure.
z Remove the air pressure sensors
before replacing the tires to prevent
the sensors from being damaged.
LS17026
TIRE PRESSURE
RESET SWITCH
The tire pressure warning system need
to be initialized in the following condi-
tions:
"
When the
pressure is changed after tire or
wheel replacement, or tire rotation,
etc
"
After replacing the ECU
"
After replacing an air pressure sen-
sor
2006 TACOMA from Jan.'06 Prod. (OM35865U)
WARNING SYSTEM
specified tire inflation
197