ATEN CS1792 User Manual page 15

No. Component
1
LED Status
Panel
2
Mode Selection
Pushbutton
3
Port Selection
Pushbuttons
4
Console Audio
Ports
5
USB 2.0
Peripheral Port
This panel contains LED icons that light to indicate mode and port
status. The Mode and Port Selection Pushbuttons each have three
corresponding LED icons that represent audio, KVM, and USB status.
Mode Selection LEDs
The KVM LED icon is a monitor.
Port Selection LEDs
The KVM LED icon is the Port
number.
This pushbutton allows you to cycle through the three modes of focus –
KVM, audio, and USB.
For manual port selection (see Manual Switching, page 13):
To bring complete focus (audio, KVM, and USB) to a computer,
either, a) press the port selection pushbutton that corresponds to that
computer; or b) press the Mode pushbutton once (the Mode pushbut-
ton's three icons light up) and then press the port selection pushbut-
ton that corresponds to that computer. All three port icons light up.
To bring only the KVM focus to a computer, press the Mode pushbut-
ton twice (the Mode pushbutton's KVM icon lights up), and then press
the port selection pushbutton that corresponds to that computer. The
port's KVM icon (the port number) lights up.
To bring only the audio focus to a computer, press the Mode push-
button three times (the Mode pushbutton's audio icon lights up), and
then press the port selection pushbutton that corresponds to that
computer. The port's audio icon lights up.
To bring only the USB focus to a computer, press the Mode pushbut-
ton four times (the Mode pushbutton's USB icon lights up), and then
press the port selection pushbutton that corresponds to that computer.
The port's USB icon lights up.
Press and hold port selection pushbuttons 1 and 2 simultaneously for
2 seconds to start Auto Scan Mode (see Auto Scanning, page 19)
Your speakers and microphone plug in here.
USB 2.0 peripherals (printers, scanners, etc.) plug into this port.
Chapter 1. Introduction
Description
Audio KVM
Audio KVM
USB
USB
7