Harman Stove Company Conquest Installation & Operating Manual page 6

6
OPErATION
Piezo Ignitor
Button
High-Low
Gas Control
PILOT
Operation
HOW TO LIGHT THE FIrE
. STOP! Read the safety information on the
front cover of this manual.
. If using the optional thermostat, set thermostat
to the lowest setting.
3. Turn off electric power to the optional blower.
4. Turn the ON-OFF switch to the OFF position.
5. Push in the gas control knob slightly and turn
it clockwise to "OFF." NOTE: THE KNOB
CANNOT BE TURNED FROM "PILOT" TO
"OFF" UNLESS IT IS PUSHED IN SLIGHT-
LY. DO NOT FORCE IT.
6. Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP! Follow the safety
information on the front cover. If you don't
smell gas, go to the next step.
7. Set the High-Low Regulator to High by turning
it fully counterclockwise.
8. Press in the gas control knob slightly and turn
counterclockwise to "PILOT."
9. Find the pilot by looking down between the
logs as shown at lower left.
0. Push the control knob fully down and hold.
Immediately push the red piezo ignitor button
to light the pilot. It is normal to have to push the
red button several times before the pilot ignites.
Continue to hold the control knob in for about
one () minute after the pilot is lit. Release
the knob and it will pop back up. Pilot should
remain lit. If it goes out, repeat steps 5 through
0.
•If the knob does not pop up when re-
leased, stop and immediately call your service
technician or gas supplier.
•If the pilot will not stay lit after several
tries, turn the gas control knob to "OFF" and
call your service technician or gas supplier.
. Turn the gas control knob counterclockwise to
"ON."
. Place the ON-OFF switch in the ON position
or turn up the thermostat setting if the optional
thermostat is used.
3. Turn on the electric power to the optional
blower if installed.
4. Set the optional thermostat to the desired room
temperature.