Table of Contents
Advertisement
WArNING: If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury, or loss of life.
A. This appliance has a pilot. When lighting the pilot, follow instructions exactly.
b. Before operating, smell all around the appliance area for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
What to do if you smell gas:
•
Do not try to light any gas appliance.
•
Do not touch any electric switch.
•
Do not use any phone in the building.
•
Immediately call your gas supplier from a neighbor's phone.
Follow gas supplier's instructions.
•
If you cannot reach your gas supplier, call the Fire Department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it. Call a qualified service technician. Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and gas control that has been under water.
1. STOP! Read the safety information above.
2. If using optional thermostat, set thermostat to lowest setting.
3. Turn off electric power to the appliance.
4. Turn ON-OFF/THErMOSTAT switch to "OFF" (center) position.
5. Push in gas control knob slightly and turn clockwise to "OFF".
NOTE: Knob cannot be turned from "PILOT" to "OFF" unless
knob is pushed in slightly. Do not force.
6. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP!
Follow "B" in the safety information (above) on this label. If you don't smell gas, go to the next step.
7. Set High-Low regulator to "HIGH" by turning fully counterclockwise.
8. Press in the gas control knob slightly and turn it counterclockwise to "PILOT."
9. Find the pilot by looking in front of the rear log, 4 inches right of center.
10. Push the control knob fully down and hold. Immediately push the red piezo igniter button to light the pilot.
It is normal to have to push the red button several times before the pilot ignites. Continue to hold the control
knob in for about one () minute after the pilot is lit. Release knob and it will pop back up. Pilot should
remain lit. If it goes out, repeat steps 5 through 9.
• If knob does not pop up when released, stop and immediately call your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service
technician or gas supplier.
11. Turn the gas control knob counterclockwise to "ON."
12. Place the ON-OFF/THErMOSTAT switch to "ON" (up) position or "THErMOSTAT" (down) position if
the optional thermostat is used.
13. Turn on electric power to appliance.
14. Set the optional thermostat to desired room temperature.
15. Set the High-Low regulator to desired setting by turning fully counterclockwise for High and fully
clockwise for Low.
OPErATION
5
Pilot Flames
Advertisement
Table of Contents
