Changing Your Switch Mode - Avocent AutoView 2000 Installer/User Manual

To broadcast to selected servers:
1. From the Broadcast dialog box, select the mouse and/or keyboard
checkboxes for the servers that are to receive the broadcast commands.
-or-
Press the Up or Down Arrow keys to move the cursor to the target server.
Then press Alt+K to select the keyboard checkbox and/or Alt+M to select
the mouse checkbox. Repeat for additional servers.
2. Click OK to save the settings and return to the Setup dialog box. Click X or
press Escape to return to the Main dialog box.
3. Click Commands. The Commands dialog box appears.
4. Click the Broadcast Enable checkbox to activate broadcasting. The
Broadcast Enable Confi rm/Deny dialog box appears.
Figure 3.17: Broadcast Enable Confirm/Deny Dialog Box
5. Click OK to enable the broadcast. Click X or press Escape to cancel and
return to the Commands dialog box.
6. If broadcasting is enabled, type the information and/or perform the mouse
movements you want to broadcast from the user station. Only servers in
the list are accessible.
NOTE: The other user is disabled when broadcast mode is enabled.
To turn broadcasting off:
From the Commands dialog box, clear the Broadcast Enable checkbox.

Changing Your Switch Mode

Your AutoView 2000 allows you to connect to attached servers using two
methods: Preemptive and Cooperative.
Chapter 3: Basic Operations
33