Scanning Your System - Avocent AutoView 2000 Installer/User Manual

30
AutoView 2000 Installer/User Guide

Scanning Your System

In scan mode, the appliance automatically scans from port to port (server to
server). You can scan up to 16 servers, specifying which servers to scan and
the number of seconds that each server will display. The scanning order is
determined by placement of the server in the list. The list is always shown in
scanning order. You can, however, choose to display the server's name or EID
number by pressing the appropriate button.
To add servers to the scan list:
1. Press Print Screen. The Main dialog box will appear.
2. Click Setup - Scan. The Scan dialog box appears.
Figure 3.14: Scan Dialog Box
3. Determine the order within the list to add the server. If there are no servers
in the scan list, your cursor will appear in a blank line at the top of the list.
-or-
To add a server to the end of the list, place your cursor in the last server
entry and press the Down Arrow key.
-or-
To add a server in the midst of an existing list, place your cursor in the line
below where you want to insert a new server and press Insert.
4. Type the fi rst few characters of a server name or port number to scan. The
fi rst matching server will appear in the line.
-or-
To move through the list, press the following keyboard commands in the Name,
Port or Time column to move through the list of servers available to scan.
a. Press Alt+Down Arrow to move the cursor down through the list
of servers.
b. Press Alt+Up Arrow to move the cursor up through the list of servers.
c. Press Alt+Home to move the cursor to the fi rst server in the list.
d. Press Alt+End to move the cursor to the last server in the list.