Avocent AutoView 2000 Installer/User Manual page 33

sensitive and may be up to 12 characters long. Legal characters are: A-Z,
a-z, Ø-9, space and hyphen.
3. In the Repeat box, type the password again and press Enter.
4. Click OK to change only your password, and then close the dialog box.
NOTE: If you should lose or forget your password, you must return your switch for service or
technical support. See Appendix C: Technical Support for contact information.
To password protect your console:
1. Set your password as described in the previous procedure.
2. Select Enable Screen Saver.
3. Type the number of minutes for Inactivity Time (from 1 to 99) to delay
activation of password protection and the screen saver feature.
4. For Mode, select Energy if your monitor is E
otherwise select Screen.
CAUTION: Monitor damage can result from the use of Energy mode with monitors not
compliant with E S
NERGY TAR
5. (Optional) Click Test to activate the screen saver test which lasts 10
seconds then returns you to the Security dialog box.
6. Click OK.
To log in to your console:
1. Press any key or move the mouse.
2. The Password dialog box appears. Type your password, then click OK.
3. The Main dialog box appears if the password was entered properly.
To remove password protection from your console:
1. From the Main dialog box, click Setup - Security; the Password dialog box
appears. Type your password, then click OK.
2. In the Security dialog box, single-click and press Enter or double-click in
the New box. Leave the box blank. Press Enter.
3. Single-click and press Enter or double-click in the Repeat box. Leave the
box blank. Press Enter.
4. Click OK to eliminate your password.
To enable the screen saver mode with no password protection:
1. If your console does not require a password to gain access to the Security
dialog box, proceed to step 2.
®
.
Chapter 3: Basic Operations
S ® compliant;
NERGY TAR
27