Table of Contents
Advertisement
S
S
UPER
ERVER 5013G-6/5013G-i Manual
FLOPPY DISK(S) fail (80)
FLOPPY DISK(S) fail (40)
Hard Disk(s) fail (80)
Hard Disk(s) fail (40)
Hard Disk(s) fail (20)
Hard Disk(s) fail (10)
Hard Disk(s) fail (08)
Keyboard is locked out - Unlock the key.
BIOS detect the keyboard is locked. P17 of the keyboard controller is pulled low.
Keyboard error or no keyboard present.
Cannot initialize the keyboard. Make sure that the keyboard is attached correctly and
no keys are being pressed during the boot.
Manufacturing POST loop.
System will repeat POST procedure infinitely while the P15 of keyboard controller is
pulled low. This is also used for M/B burn in testing.
BIOS ROM checksum error - System halted.
The checksum of ROM address F0000H-FFFFFH is bad.
Memory test fail..
BIOS reports the a memory test fail if the onboard memory has an error.
®
Unable to reset floppy subsystem.
®
Floppy Type dismatch.
®
HDD reset failed
®
HDD controller diagnostics failed.
®
HDD initialization error.
®
Unable to recalibrate fixed disk.
®
Sector Verify failed.
A-4
Advertisement
Table of Contents
